COMPRESSION / FLEXURAL TESTS, 200 kN MAX. CAPACITY LOAD
TENSILE TESTS, 50 kN MAX. CAPACITY LOAD
With automatic load or displacement/deformation control, for
CBR (California Bearing Ratio)
DIRECT SHEAR (Leutner) on the connection between bituminous
FLEXURE ON BEAMS AND TILES
FLEXURE on 40x40x160 mm specimens
COMPRESSION on cubes 40, 50, 70 mm
METAL, PLASTIC, WIRES, ROPES, TEXTILES, PAPERS ETC.
TENSILE TESTS, 50kN max capacity load
ROCK AND STONES:
UNIAXIAL SPLITTING TENSILE
By using suitable devices, Unitronic tester, within the limits of its max. 200 kN capacity for compression/flexural and 50 kN for tensile, performs
compression, flexural, splitting tensile and direct tensile tests, with automatic load or displacement/deformation control.
The load is applied by a mechanical jack that is driven by a motor brushless with closed loop through optic encoder and controlled by a
microprocessor. Stroke electric end switches are applied to the load piston to save the machine from accidental handlings.
The two crossheads foresee couplings to fix the different test devices (see accessories). The stress is measured by an electric load cell; the
measurement and the displacement control of the crosshead is achieved by the electronic device incorporated into the machine.
Electronic control unit “Cyber-plus Evolution” with Touch-Screen
colour display, that runs like a standard PC based on Windows
operating system for the management and analysis of the data,
test results, graphs.
The Touch-Screen icon interface allows an easy set up of the
parameters and immediate execution of the test.
The machine can be connected to a PC for remote test execution
through suitable Software; the machine can in any case perform
the tests without any external PC, because of the “Cyber-Plus”
grants performances like a PC.
Direct connection to Intranet (connection to a LAN network) and
Internet to establish a remote communication and receive an
immediate diagnostic analysis from Matest technicians, or for
updates of the software.
Unlimited memory storage with: 2 USB ports, 1 SD card slot.
RJ45 network connection
Possibility to select different languages.
Hardware technical details: see p. 18
SPECIFICATIONS OF THE FRAME
Max. load: 200 kN Compression; 50 kN tensile.
Max. vertical daylight: 900 mm (without accessories)
Max. vertical daylight with compression platens: 800 mm
Compression platens diameter: 216 mm (upper platen on seat ball)
Distance between columns: 650 mm
Crosshead travel: ± 200 mm (400 mm total)
Testing speed range: from 0.01 to 100 mm/min
Load rate: from 1 N/s to 5 kN/s
Displacement resolution: 0.01 mm with accuracy better than 0.2%
Machine Class: 1
The Unitronic 200 kN is supplied complete with:
Electric load cell 200 kN capacity, crosshead displacement device,
upper with seat ball and lower compression platens.
Are not included: accessories and software for specific tests that
must be ordered separately (see accessories).
Note: The machine can be equipped with intermediate load
cells to the max. capacity of the machine, to satisfy
specific test requirements.
Power supply: 230V 1ph 50-60Hz 850W
Dimensions: 950x560x2400 mm
Weight: 820 kg approx.
S206N UNITRONIC 200 KN CAN PERFORM THE FOLLOWING TESTS:
S206N UNITRONIC 200 KN, CAN PERFORM THE FOLLOWING TESTS: