Menu Close

VERIFICATION OF FORCE TRANSFER

Category:

STANDARDS: EN 12390-4 | BS 1881:115 | DIN 51302
The equipment to perform this test is composed of:

C155N
DIGITAL MEASURING TESTER
CYBER PLUS EVOLUTION TOUCH-SCREEN
This unit reads simultaneously the four values supplied by the
electric strain load cell. The values are memorized, automatically
elaborated and visualized, to directly supply the various coefficients
resulting by the calculations, and printed on laser printer (accessory
C128) directly connected via USB to the tester.
The unit, through the wide display, shows to the utilizer the different
test procedures, as requested by previously selected specification
(EN, BS, DIN).
At the end of the test, the display automatically visualizes the test
results, by informing also if the frame under test is conforming
to the requirements of the selected specification as regards the
stability (axial transmission of the loads, self-alignment of the seat
ball etc.).
The digital readout unit is also foreseen of a fifth digital reading
channel allowing to perform load calibration tests on compression
machines up to 3000 kN capacity.
Supplied complete with kit of 5 cables and connectors for load cell
coupling, accessories, carrying case.
Power supply: 230V 1ph 50Hz
Dimensions: 450x350x160 mm
Weight: 8 kg approx.

C154
ELECTRIC STRAIN LOAD CELL 3000 KN CAPACITY
Consisting of a strain steel cylinder where four balanced strain
gauge bridges are centered to measure the deformation on 4
generatrix in relation with two diameters, orthogonal between them,
so that both axial and circumferential deformations can be
measured.
The cell incorporates a fifth strain gauge utilized for load measurement
calibration tests.
Supplied complete with connectors, cables, calibration certificate.
Dimensions: Ø 130 by 200 mm high.
Weight: 18 kg approx.
C154-01
POSITIONING DEVICE
Manufactured with special steel, hardened and rectified, it allows to
correclty position the load cell on the lower platen of the compression
frame, to carry out the footemeter test as described by the
Standards.
Dimensions: 150x150x50 mm
C155-05
CALIBRATION PROCESS of the load cell to the digital tester, complete
with Matest calibration certificate.
ACCESSORY (recommended)
C155-10N SOFTWARE
To download to PC the results with possibility of certificate
printout. Supplied on CD Rom for PC installation.